General Category > French Sandcasts
More and more surprising!! VIN-1014046/E-1014138
kp:
All the details of the differences are on the website under technical There are more than just that casting difference
DW69K0:
KP,
Maybe I am not looking in the right place, but I can't find this mentioned or pics of early cylinder jug. Are there noticeable differences in the earlier cylinder jugs on the Sandcasts through the different engine vins? Are Sandcast cylinder jugs different from the die-cast?
Thanks for any help,
DW
kp:
Ok Don't know where they went ???
DW69K0:
From what I understand the cylinder jugs produced with the extra hole on the front of the cam chain roller were used on the Sandcasts and die-cast cylinder jugs, but there are no outer appearance difference until they started to die-cast the jugs sometime at the end of the K1 unit production, is that correct?
DW
Marcello Tha:
--- Quote from: DW69K0 on April 05, 2014, 07:15:20 pm ---From what I understand the cylinder jugs produced with the extra hole on the front of the cam chain roller were used on the Sandcasts and die-cast cylinder jugs, but there are no outer appearance difference until they started to die-cast the jugs sometime at the end of the K1 unit production, is that correct?
DW
--- End quote ---
Correct until E26143, cylinder jugs without the extra 6x90 bolt.
Marcello
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version