Honda CB750 Sandcast

Rolled Rear Wheel (rim)

Wayne · 9 · 7122

Wayne

  • Administrator
  • Hero Member
  • *****
    • Posts: 1044
    • View Profile
Looking at my rear wheel it does not appear to be the rolled rear wheel that has been decribed in other threads and from pictures I have looked at. This leaves me somewhat puzzled as to what would be the "correct" wheel for this bike. (576/748) I spoke with the last owner, who called the original owner and he says the wheels were never replaced. Can someone tell me what wheel I have here and is it "correct" for the bike?
[size=


Nielsen

  • Newbie
  • *
    • Posts: 29
    • View Profile
I do not know, but on my rims the "DID" mark are on the center of the rim, close to the tube valve.


kp

  • Administrator
  • Hero Member
  • *****
    • Posts: 1808
    • View Profile
Take a few good quality and well lit close up shots and email them to me. The spoke grove looks to be the deep type which was unique to the rolled rim but the picture is just not clear enough to tell KP
Yabba Dabba KP


Steve Swan

  • Hero Member
  • *****
    • Posts: 2705
    • View Profile
    • cb750sandcastonly.com
Wayne,

Looking at wheel pics on your website, i am going to bet the house your rear rim is the correct round bead type.

Compare the face of rear rim bead to that of the face on the front rim bead. The differences betwwen the two bead faces should be readily evident.

The front rim bead has an obvious flat face which is in contrast to lack of any flat bead on on rear rim.

KP has an eye like a hawk, if you send him pics, he'll be able to tell.


donzie

  • Jr. Member
  • **
    • Posts: 56
    • View Profile
The rear rim shown on your websight is for sure the correct "rolled" rim


Wayne

  • Administrator
  • Hero Member
  • *****
    • Posts: 1044
    • View Profile
Thanks guys. I was comparing to one I came across in a post on here that seemed to have a very pronounced center area. It seemed much higher than mine. Maybe an optical illusion as it was quite rusty. I sent some high res photos to KP. For the curious amongst you here they are:

http://1969cb750sandcast.com/images/wheel_1.jpg
http://1969cb750sandcast.com/images/wheel_2.jpg
http://1969cb750sandcast.com/images/wheel_3.jpg
[size=


cb7504

  • Sr. Member
  • ****
    • Posts: 290
    • View Profile
Wayne:
It is a rolled rear rim with out a doubt, correct for your bike. Marty K.


Wayne

  • Administrator
  • Hero Member
  • *****
    • Posts: 1044
    • View Profile
Thanks guys! That's one less part to scrounge for! As I learn what I have here, I think I'm pretty lucky!
[size=


chrisnoel

  • Full Member
  • ***
    • Posts: 193
    • View Profile
Rear rim should have more of a quarter round edge than the front. Looks good in the picture but comparing it to the front rim will make it a dead give away.