Honda CB750 Sandcast

The Restoration Shop => Fenders (mudguards) and Seats => Topic started by: Bickle on February 26, 2010, 06:57:03 pm

Title: Rear Fender
Post by: Bickle on February 26, 2010, 06:57:03 pm

Not sure if this has been covered...don't remember it...but I'm getting old.

The early rear fender wire holding tabs on the side ...the wire passes through horizontally and the newer ones appear to pass through vertically. Different tab orientation. Has this been noted before? Is it in the website?

Steve

Title: Re: Rear Fender
Post by: Steve Swan on February 26, 2010, 06:57:32 pm

I'm getting old too, Steve.

I don't recall this detail being identified.

Good observation, Steve.

Title: Re: Rear Fender
Post by: Riccardo on February 26, 2010, 06:58:21 pm

Hi to all.
Steve,
Look Nishimatsu store.
Nishimatsu builds a "limited" perfect repro of the old rear fender.
Riccardo

Title: Re: Rear Fender
Post by: patriotcommercial on February 18, 2015, 02:44:18 am

I think I stumbled on a very good condition, two hole rear fender today.  It appears to be exactly the same as the one on my Sandcast.  Is there any place where a part number or a way to ID the part.  It has the tail light attached , almost perfect.  Maybe my lucky bastard moment ?.