Honda CB750 Sandcast

The Restoration Shop => Engine Electrical => Topic started by: vnz00 on March 02, 2012, 04:47:31 am

Title: Braided Earth Wires - Flat/Round VIN #
Post by: vnz00 on March 02, 2012, 04:47:31 am

Hi all,
I pulled a round braided earth wire off #5528 the other day. I know these were used into the early K0s.  But there is also a flat braided wire too. Any idea of what the VIN cut off was from one to the other?  Also how close is the Yamiya repop?

Also, how are these finished? Are they tinned copper braid I.e. a dull silver finish, or are they a zinced finish.

Thanks all,
Steven V.

Title: Re: Braided Earth Wires - Flat/Round VIN #
Post by: steff750 on March 02, 2012, 06:38:31 am

i have a  flat one tinned copper braid  i think, i have not seen it in years so not sure, i know its here? it was  on a 1970 cb750 #10152**

Title: Re: Braided Earth Wires - Flat/Round VIN #
Post by: Steve Swan on March 02, 2012, 11:31:29 pm

Steven, can you provide pictures ?

Title: Re: Braided Earth Wires - Flat/Round VIN #
Post by: vnz00 on December 17, 2012, 05:17:25 pm

Well I finally got around to taking a photo of the two original Honda ones I have. Note the round one is a tighter braid than the flatter one.

The Yamiya one is very broad and flat, and I don't have one handy. But much different compared to standard

Does anyone know which is earlier?

Thanks, Steven

Title: Re: Braided Earth Wires - Flat/Round VIN #
Post by: Steve Swan on December 17, 2012, 08:17:21 pm

IF my memory serves me correctly, the flat looser braid is what i have on 232, which came with the amazingly complete chassis.  IF i recall correcty, 2157's cable is same as 232.

Title: Re: Braided Earth Wires - Flat/Round VIN #
Post by: vnz00 on December 17, 2012, 08:20:07 pm

Cool, thanks Steve. I thought as much but I just wanted to be sure.