Honda CB750 Sandcast
The Restoration Shop => Lighting Systems and Chassis Electrical => Topic started by: sandguss on January 25, 2019, 10:06:24 am
-
A question to all members : The Part Book from 69.4 shows two bolts for the rear winker stay with the part no. 92000-08032-0B ( page 123 no. 18 ) this is a chrome Bolt and not a large no. " 8 " bolt.
my question: what is the correct Bolt ?
thanks for help
Manfred
-
My notes show that 97 and 1553 both had "8" head screws.
-
thanks Mark!
-
Thank you for your post, Manfred. I agree with Mark.
-
That is an interesting question. Of the 1/2 dozen or so sandcast machines I've owned, not one of them came with the rear turn signal assemblies fitted to the bike. I kid you not, not one had rear turn signals. I've had to buy them all off eBay. In fact I purchased that set of assemblies just auctioned by our good friend markivmotors to go on a bike I've just purchased without these items fitted. Would you also believe the mounting bolts supplied with these parts were from something other than a Honda.
Yep that's a good question. Does anyone know if the #8 bolt continued to be used throughout production and if so did a change occur from the large 8 to the small 8
-
All of my Sandcasts have large 8 bolts, with my highest being ViN 4349. I checked a December built K0 And it has small 8 bolts. Someone with a higher Sandcast VIN number will have to weigh in for the large 8 cut-off point.
Best,
Duane
-
ok thanks again for help
-
Thanks for the info Duane