Honda CB750 Sandcast

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Joe K

Pages: 1 2 3 4
46
The Archives / Re-Keying the Steering Head Lock
« on: February 19, 2010, 07:26:24 pm »
Hello,

Does anyone know if it is possible to re-key the steering head lock under the triple tree? Do I need to purchase an old Honda key to do this?

Thank you,
Joe

47
Engine Mechanical / Gasket Installation with Gasket Sealant?
« on: February 19, 2010, 04:07:19 pm »
Question ,  :-[

When installing engine gaskets on the cylinder head, piston head, clutch cover, oil pan, etc. do you:

Also put silicon gasket sealant on both sides of the gasket?
or
Put only the gasket on?

Thank you,
Joe

48
Engine Mechanical / Engine Smoking Oil from Oil Lines
« on: February 19, 2010, 04:05:38 pm »
My motor is now smoking oil out of the top valve cover oil line and top oil reservoir tank oil line. No smoke/oil is coming out of the exhaust pipes. Has anyone experienced this before? I will need to check the timing and do a compression test. I am not sure about the milage. Maybe a piston ring has broke. Any advice will be helpful. I want to do an engine re-build anyway, but later rather than sooner.

Thank you,
Joe

49
Engine Mechanical / Chain Oiler at Front Sprocket
« on: February 19, 2010, 03:57:01 pm »
Hello Fellow Sandcast and K0 Junkies:

Does anyone have any suggestions to stop the oil from coming out the little hole near the front sprocket? I am assuming this is to oil the chain, but it is also oiling my driveway and I want it to stop.

Thank you,
Joe

50
The Archives / 1969 K0 Diecast Members Should be Member Too
« on: February 19, 2010, 03:48:30 pm »
I own a 1969 CB750 K0 built 10/69. Can we be added to the Sandcast Membership with under a the title "1969 CB750 Diecast" or something like that? I think we deserve some recognition too? Suggestions?

Thank you,
Joe

51
Gauges - Levers and Cables / Turn Signal and Nuetral Plastics
« on: February 18, 2010, 09:01:30 pm »
Hello,

Does anyone know where I can find the small color plastics for the turn signal and the nuetral on the speedo and odo?

Thank you in advance,
Joe

52
Gauges - Levers and Cables / K0 White Plastic Speedo and Odo's
« on: February 18, 2010, 08:52:45 pm »
I just purchased some really good replica K0 speedo and odo adhesives to put over the old face plates. Problem is the face plates are warped. Does anyone know where I can get white plastic or does anyone have unusable old face plates so I can properly adhere the new faces?

Thank you,
Joe

53
Parts Q&A's and Feedback. / K0 Right Control Switch Button
« on: February 18, 2010, 08:51:21 pm »
Other than e-bay, does anyone know where I can get a K0 right control switch button? Red is OK, Black is even better.

Thank you,
Joe

Pages: 1 2 3 4