Honda CB750 Sandcast
Buy and Sell => Parts Wanted => Topic started by: kp on March 20, 2011, 05:38:47 am
-
Fellas, I'm in need Does anyone have an early Tacho and an early 2 hole air box for sale. I'll pay good. Thanks KP
-
Sorry kp,
I cannot help you, i do not have these parts.
About 2 holes, i should yhink at modify the DSS 3 holes.
It's only a my idea.
-
KP
I got LPM to send me one not drilled. I have played with it a bit to try and take the reliefs out. At fist I thought it would be a piece of cake as it was very flexible with a little heat from my heat gun but this stuff has a very elastic quality and it's hard to make it stay in the desired contour. I have come to the conclusion that the only way to do it would be to make an inner and outer mold for each corner, heat the material, sandwich and clamp the piece in the mold halves. Probably not a big deal, I have just been a bit too busy. Remember, the reproductions are smaller overall as well. (not sure about the Yamiya)
As you know I'm trying to finish my original early 2 hole box as well. I just need a good center piece so I can get the right contour on the lip etc. I watch Ebay 10 times a day at least for air boxes. If I find one I'll either buy it for you or let you know right away.
-
But LPM can do a little production of 2 holes for us?
-
I think it was discussed riccardo. I know they will send one not drilled so you can make a 2 hole with reliefs. Whether they will do a small run without reliefs I think is unknown at this point. Someone would have to take the lead on this and work with LPM and members to make it worth while.
-
KP, I've got a question about the air box. The rubber tubes that fit inside the top. Do they tilt upward or downward?
Thanks,
1941wld
-
Hi Kerry,
What tacho do you need exactly? There are several early tachos. I do have one with the sandcast cable connection, restored with a Yamiya cover and of course a new face. Given the fact that these are very rare, I cannot sell this as a bargain
-
Hi Marcel
Pre VIN 500
I don't expect to have it for free But mid production sandcast clocks I have but I'm looking for the earliest know one or at least one for restoration
Thanks
KP
-
Hi Marcel
Pre VIN 500
I don't expect to have it for free But mid production sandcast clocks I have but I'm looking for the earliest know one or at least one for restoration
Thanks
KP
May be Bojje can help you?
-
Yes I spoke with Bo. Thanks Marcel KP