Honda CB750 Sandcast

The Restoration Shop => Fenders (mudguards) and Seats => Topic started by: 4pots1969 on July 19, 2017, 09:13:53 am

Title: The exact length of the low cut at the high cut
Post by: 4pots1969 on July 19, 2017, 09:13:53 am

Who would have the kindness to measure the exact length of the low cut at the high cut and millimeter near a front fender double cuts?
Because I may have found one but I want to be sure that it is not a K0 diecast that has been shortened...
Thanks, ;)

Title: Re: The exact length of the low cut at the high cut
Post by: DW69K0 on July 19, 2017, 07:42:48 pm

Hi Gerard,
I am not sure I understand your question, are you looking for the length of the double cut front fender?
Here is best advice. Front top of fender from center of top stay bolt hole length to front cut is 71mm.
The bottom of fender from center of bottom stay to cut edge is 93mm.
It is possible to cut the front of a KO fender to correct length, but bottom of K2 fenders are not long enough to make it the correct 93mm length, they are to short on the bottom to make the correct length.
Hope all this makes sense when translated.
Best,
DW