Hi ,Manfred , I once bought a body set from you and you did my K1 Carb refurb.
What price are you asking and method of shipping as you may remember I am in the UK
Thank you Garry

Hi Does anyone have a spare genuine sandcast seat strap and genuine screws two straps if possible please.
Garry🏍🇬🇧😊

Hi I have just had two sets of spokes and nipples re-plated  and the rear wheel dressed up perfect but when it came to dressing the front wheel all the spokes would not even try to enter the thread in the nipple after a lot off head scratching and phone calls and enquiries on thread sizes etc I was approached by a retired motorcycle mechanic who told me to clean up every single spoke threads using my bench grinder with a wire wheel attached.The result was perfect. Which I assumed was just slightly removing some of the plating thickness.
Hope this works for all out there.
Garry🇬🇧😁

Wheels are almost ready and have new Gold Seal.


Hi Uji, Are the wheel hubs lacquered or just left polished.
Wheels  very nice finish as usual to your standards.
Garry 🇬🇧😄

Can anyone tell me the best method and type of lacquering for the wheel hubs, engine covers and fork sliders.
Thank you Garry 🇬🇧😄

Hi Mark, On your sandcast 87 refurb on page,page 35 you showed a picture on two thin lipped alternator covers
they where both clear coated, then you where about to paint the Honda logo black(Matt black I take it ).
Can I ask is that the correct procedure Polish,Clear coat, then paint the Honda logo, Why not polish, paint the Honda logo then clear coat.

I take it it is so the Honda logo keeps the matt black look is that correct ?.
Thank you Garry

Hi, Should  the engine covers and fork sliders be lacquered also linished or sisal finish.
Garry🇬🇧

Can anyone tell me the exact finish for triple tree top and handlebar brackets,I was under the impression they should be a satin finish.
Was it satin from the first sandcast throughout all models. Also paint or anodising.
Thank you Garry  🏍