1
General Discussion / Re: Non-wrinkle tank date of manufacturing identification number
« on: January 05, 2020, 04:42:47 am »
i have all original 10172## non wrinkle
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1
2
General Discussion / Re: Is this the real thing?
« on: October 20, 2019, 06:34:23 am »
absolutely nothing sandcast about it, mostly K1/2 bitsa, the seller is trying his luck looking for a sucker
3
General Discussion / Re: Double Cut Mudguards/Fenders & #8 Bolts
« on: October 03, 2019, 12:17:05 am »
dunno about the yamiya ones but you can spot those vietnam fenders from a mile away, they have the wrong radius and look like #@%$, the main bracket mount holes are in the wrong spot the stays are just wrong everywhere and nothing actually fits without using levers/blocks and hammers etc , i have one on one of my bikes and regret buying it.. you get what you pay for !!
4
Front End and Suspension / Re: Forks sliders oddity
« on: September 03, 2019, 04:05:13 am »
Hi Don, not sure if you get my question ,the K1 and K2 have a much different full taper , are yours like this ? the K1 K2 use the 48mm seal, both the ones in my first pic se the 46mm seal
5
Front End and Suspension / Forks sliders oddity
« on: August 21, 2019, 05:01:38 am »
Hi all, thought this might be of interest to some.. Everyone says all Sandcast and KO use the same forks ,....currently doing a diecast resto 12/69 and found front slider oddities , anyone have any idea when these slightly tapered at the seal area sliders came into play.? they are definitely both pre K1,. obviously one has been changed at some early stage, pic shows both sliders from same bike, which one is correct ? the Brighton bike has the same slightly tapered ones. Both have identical internals.
6
General Discussion / Re: Mystery engine shaft ?
« on: January 14, 2019, 10:36:25 pm »
or maybe a different primary chain tensioner set-up
7
General Discussion / Re: Mystery engine shaft ?
« on: January 14, 2019, 10:33:31 pm »
my guess is that maybe they originally intended to use it as an oil pump drive driven off the clutch basket, i checked the die cast cases i have laying about and there is no provision for it, although the space is still maintained ,.,,another sandcast oddity
8
General Discussion / Re: Mystery engine shaft ?
« on: January 14, 2019, 12:29:50 am »
just grabbed a pic from sooc files to save resizing ,(shaft housing arrowed)
9
General Discussion / Re: Mystery engine shaft ?
« on: January 13, 2019, 07:11:08 pm »
anyone have any thoughts on this ?
10
General Discussion / Mystery engine shaft ?
« on: September 24, 2018, 09:12:16 am »
Just wondering if anyone would know why there is a machined shaft/spindle castings in the lower cases at the bottom right side of the clutch (inside the clutch housing area.) The curve on the lower r/h side of the clutch cover allows for something.Seems the cases were designed for something ?? anyone else picked up on this?
sorry couldnt figure out how to upload a pic..
sorry couldnt figure out how to upload a pic..
11
Links to Auctions and Classifieds / Re: unstamped cases? ebay
« on: September 02, 2018, 04:54:26 am »
definately sandcast cases, and not honda font ,probably stamped to suit the later frame it was fitted to.
Pages: 1