Technical/Restoration Support

14. Brakes

This lower hose was used on Early Production Machines.  The banjo end had a short neck.  Who knows at what VIN this hose stopped being used ?

 

Rear Brake Pedal - Clamping Slot Parallel to Pedal Arm Center
Later Slot at "2pm"Angle - Not used on VIN 7414 & earlier

Caliper Backing Plate - Shallow Countersink        Master Cylinder Mirror Boss - 26mm high
Later 'K0' type plates had deeper CS & fins         Later 'K0' type cyl is 31mm high

Early Reservoir - No fill level ring

Late Reservoir - Note fill level ring

Back to Table of Contents